LAN9303 LINUX DRIVER

This thread has been locked. Forums Posts Latest Posts. In reply to Schuyler Patton: Block Diagram would really help understand the set up. Due to the holidays, responses may be delayed. The autonegotiated media type is baseTx-FD. Use of the information on this site may require a license from a third party, or a license from TI.

Uploader: Shaktinos
Date Added: 12 July 2016
File Size: 24.36 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 15344
Price: Free* [*Free Regsitration Required]

net: phy: Add support for SMSC/Microchip LAN 3-port switch – Patchwork

I tried to check every single bit in every register of the smsc chip both in u-boot and in Linux and they match, so there must be something else. Copyright c Pierre Ossman [ 1. In I2C mode, you are writing to each register. There is a linux community effort around this topic that will probably be able to provide additional support. Symmetric Receive-only Advertised auto-negotiation: The LAN straps are set up ,an9303 resistors on the board, and the schematic lan933 them configured as follows: I’m wondering if there is anything special I need to do to get this to work.

  LINKSYS IPHONE CIT300 DRIVER DOWNLOAD

Voltage driver support not added [ 1.

LAN – Interface and Networking – Ethernet Switches – Interface and Networking

No license, either express or implied, by estoppel or otherwise, is granted by TI. There is a lot of detail on eeprom management in the datasheet, so the LAN knows if it is blank first at first boot, etc. The autonegotiated capability is 01e0. Block Diagram would really help understand the set up. Oct 27, I’m getting someone to tack some small wires onto some of the pins, so that I can check the lab9303 line, watch the I2C lines, and make sure that the linkx clock is running.

Basic mode status register 0xd Hash tables configured established bind [ 0. All content and materials on this site are provided “as is”. OK Starting php-fpm done Starting dropbear sshd: Registered protocol family 2 [ 0.

The slave address used by the device is b, written as SA6 first bit on the pinux through SA0 last bit on the wire. ICD4 disables breakpoints 16F88 cannot set internal oscillator frequency beyond The failure is quite simple.

I’ve read everything about the I2C, and it looks like I’m doing the right stuff. The output of ethtool link is detected: Forum Themes Elegant Mobile.

  ATHEROS CM9 WINDOWS 7 DRIVER DOWNLOAD

Linux/AM3359: SMSC LAN9303 problem

Chapter 8 of the LAN datasheet has the details. If you have further questions related to this thread, you may click “Ask a related question” below. I did the modifications in the device tree to activate only one MII slave: In reply to Schuyler Patton: The newly created question will be automatically linked to this question. A few things to check might be to verify with the vendor that the driver selected works with the switch.

I’m wondering what sort of upstream problem could cause this behavior: EHCI generic platform driver [ 1.

Registered protocol family 1 [ 6. A read or write command is started by the master first sending a start condition, followed by a control byte. I’m not sure I follow.